Siemens SINUMERIK 840Di Function Manual page 1593

Number Identifier: $MA_
35150 SPIND_DES_VELO_TOL
35160 SPIND_EXTERN_VELO_LIMIT
35200 GEAR_STEP_SPEEDCTRL_ACCEL[n]
35210 GEAR_STEP_POSCTRL_ACCEL[n]
35220 ACCEL_REDUCTION_SPEED_POINT
35230 ACCEL_REDUCTION_FACTOR
35300 SPIND_POSCTRL_VELO
35350 SPIND_POSITIONING_DIR
35400 SPIND_OSCILL_DES_VELO
35410 SPIND_OSCILL_ACCEL
35430 SPIND_OSCILL_START_DIR
35440 SPIND_OSCILL_TIME_CW
35450 SPIND_OSCILL_TIME_CCW
35500 SPIND_ON_SPEED_AT_IPO_START
35510 SPIND_STOPPED_AT_IPO_START
35590 PARAMSET_CHANGE_ENABLE
36060 STANDSTILL_VELO_TOL
36200 AX_VELO_LIMIT
5.2 Setting data
5.2
5.2.1 Channel-specific setting data
Number Identifier: $SC_
42600 JOG_FEED_PER_REF_SOURCE
42800 SPIND_ASSIGN_TAB
42900 MIRROR_TOOL_LENGTH
42910 MIRROR_TOOL_WEAR
42920 WEAR_SIGN_CUTPOS
42930 WEAR_SIGN
42940 TOOL_LENGTH_CONST
Spindles (S1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Description
Spindle speed tolerance
Spindle speed limitation via PLC
Acceleration in speed control mode
Acceleration in position control mode
Speed limit for reduced acceleration
Reduced acceleration
position control activation speed
Positioning direction of rotation for a non-
synchronized spindle
Oscillation speed
Oscillation acceleration
Oscillation start direction
Oscillation time for M3 direction
Oscillation time for M4 direction
Feed enable with spindle in setpoint range
Feed enable with stationary spindle
Parameter set definition possible from PLC
Threshold velocity "Axis/spindle stationary"
Threshold value for velocity monitoring.
Description
Revolutional feedrate control in JOG mode
Spindle number converter
Mirror tool length offset
Mirror wear values of tool length compensation
Mirror wear values of machining plane
Invert sign of all wear values
Retain the assignment of tool length components
when changing the machining plane (G17 to G19)
Data Lists
5.2 Setting data
5-3