All Other Faults; Log Book; Fault Messages In The Log Book - ProMinent DULCO flex Control Operating Instructions Manual

Troubleshooting
Fault description
No. 5: The identifier and the message
'Fan warning' appear.
No. 12: The identifier and the mes‐
Q
'Invalid metering volume' appear.
sage
No. 13: The identifier "Temperature"
C
'Temperature' F
and the message
appear.
16.2.3

All other faults

16.3

Log book

16.3.1

Fault messages in the log book

Tab. 20: Errors
Log book no.
0
1 The pump is in
programmed in the
2 The pump is in
programmed in the
3 The fluid level in the storage tank has reached "Liquid level low 2nd
4
5
6
7
8
9
10
11
12
13
14
15
16 The memory for revolutions, which have not yet been processed, has
92
Cause
The fan is faulty or not con‐
nected.
The set metering volume in con‐
centration mode cannot be
metered.
The temperature is too high.
Please contact the responsible ProMinent branch or representative!
For more information on the 'ERROR' messages - refer
to the chapter "Fault messages on the LCD screen".
Description
System, EEProm error*
'Analog' operating mode, a fault behaviour has been
'Analog' menu and the control current has fallen
below 4 mA.
'Analog' operating mode, a fault behaviour has been
'Analog' menu and the control current has risen
above 20 mA.
stage".
The pump hose has a leak.
The state of the dosing monitor is not as expected.
-
The ambient temperature is too high or too low.
-
-
An incorrect parameter has been entered.
-
-
The mains voltage is too low or not connected.
-
-
overflowed.
Remedy Personnel
Return the pump to Instructed per‐
ProMinent. sonnel
Adapt the metering Technical per‐
parameters. sonnel
Rectify the cause. Technical per‐
The pump starts up sonnel
automatically.
Acknowledge?
X
-
-
-
-
X
-
-
-
-
X
-
-
-
-
-
X