Operation; Manual Operation - ProMinent DULCO flex Control Operating Instructions Manual

13

Operation

13.1

Manual operation

Stop/start pump
Priming
Starting a batch
Acknowledge errors
Check adjustable variables
Change directly adjustable variables
Changing a variable in the relevant contin‐
uous display:
User qualification: Instructed person - see
on page 12
This chapter describes all the operating options in a continuous display
(several symbols and the pressure display appear at the top in the black
bar) for the trained person at the pump.
Please also refer to the "Operating/Setting overview"
–
and "Continuous displays and secondary displays"
overviews at the end of the operating instructions
and also the "Overview of equipment and control
elements" chapter.
[STOP/START] .
Stop the pump: Press
Start the pump: Press [STOP/START] again.
[Priming] .
Press
[Clickwheel] to extend or shorten the priming time during priming.
Turn the
'Batch' operating mode: Press the [Clickwheel] in the 'Push' contin‐
In
uous display.
[Clickwheel] to acknowledge error messages that require
Press the
acknowledgement.
In a continuous display: Another continuous display appears each time the
[Clickwheel] engages when turned. (The number depends on the configu‐
ration.)
[Clickwheel] .
1. Press the
ð The variable can be changed (highlighted).
2. Turn the [Clickwheel] .
ð The variable is changed.
[Clickwheel] .
3. Press the
ð The variable is saved (the highlighting disappears).
If the "lock" - "lock all" has been set - see
Control' on page 82 , first enter the 'Password' after pressing the
[Clickwheel] .
List of directly changeable variables:
Capacity
n
Contact volume
n
Batch dosing time
n
Operation
Ä 'Qualification of personnel'
Ä 'Set-up overview DULCO flex
81