Initial Commissioning - ProMinent DULCO flex Control Operating Instructions Manual

Initial commissioning

11 Initial commissioning
42
User qualification: Technical personnel and service - see
of personnel' on page 12
WARNING!
The rotating rotor may catch and trap body parts.
– Only use the pump hose in the dosing head as out‐
lined in the instructions provided below.
The user should only now install the rotor half supplied - this will extend
the bearing service life of the pump hose.
Fig. 29: Starting state of rotor (bearing cover not shown)
1.
If still necessary: Press
stop (manually).
'Hose replacement' menu - used here to fit the hose.
2. Go to
'Go to change position?' appears.
ð
WARNING!
The rotating rotor may catch and trap body parts.
– Only take off bearing cover once the pump prompts
you to do so.
– Refit bearing cover once prompted to do so by the
operating instructions.
3. Confirm the question with
ð The rotor turns slowly and the following appears:
' Please wait...' .
The rotor stops and
Rotor!' appears.
Ä 'Qualification
[STOP/START] to bring the pump to a
'Yes' .
'Please remove cover and take out the
P_DX_0065_ SW