Warning Messages In The Log Book - ProMinent DULCO flex Control Operating Instructions Manual

Log book no.
17 The pump is in
iour has been programmed in the
18 The pump is in
iour has been programmed in the
19
20 The bus contact between the optional module and control room has
21 Communication between the optional module and pump electronics is
22 The associated heartbeat message was no longer received by the front
23
24
25
26
27
28
29
30
16.3.2

Warning messages in the log book

Tab. 21: Warnings
Log book no. Description
0 The fluid level in the storage tank has reached "Liquid level low 1st stage".
1 The pump hose has a leak.
2 The state of the dosing monitor is not as expected.
3 The set metering volume in concentration mode cannot be metered.
4 A set parameter is invalid.
5 The fan is faulty or not connected.
6 -
... ...
11 -
12 The set metering volume in concentration mode cannot be metered.
13 The temperature is too high.
Description
'Analog' -"xx. side band" operating mode, a fault behav‐
has fallen below 4 mA.
'Analog' -"xx. side band" operating mode, a fault behav‐
has risen above 20 mA.
been disconnected. *
not working.
assembly for a certain period of time.
Problems with compatibility with the assemblies' firmware. *
System or EPRom error
Pump restart, initialisation incomplete.
The motor indicates a fault.
The fan is faulty or not connected. *
RS485 communication is interrupted.
The motor indicates a fault. *
The motor is blocking. *
* Please get in touch with the ProMinent head office should this fault
occur.
'Analog' menu and the control current
'Analog' menu and the control current
-
For more information on the 'WARNING' messages -
refer to the chapter "Warning messages on the LCD
screen".
Troubleshooting
Acknowledge?
-
-
X
-
-
-
X
X
-
-
-
-
-
X
93