Troubleshooting; Faults Without A Fault Message; Faults With Error Message; Fault Messages On The Lcd Screen - ProMinent DULCO flex Control Operating Instructions Manual

16

Troubleshooting

Safety information
16.1

Faults without a fault message

Faults without a fault message
Fault description
Fluid escaping from the
liquid end.
Green LED display
(operating indicator) not
lighting up.
16.2

Faults with error message

16.2.1

Fault messages on the LCD screen

User qualifications - see following table and
on page 12
Cause Remedy
The pump hose has a Replace the pump hose - refer to the "Repair"
leak. chapter.
If a pump hose rupture has been indicated, clean
the hose rupture indicator - refer to the "Repair"
chapter.
The wrong mains The specified mains voltage as per the voltage
voltage or no mains specification can be found on the nameplate.
voltage is connected.
In the event of a fault:
the red LED display lights up.
n
an identifier and a message appear on the LCD screen.
n
the pump stops.
n
WARNING!
Warning of hazardous feed chemical
Should a dangerous feed chemical be used: it may
escape from the hydraulic components when working on
the pump, material failure or incorrect handling of the
pump.
– Take appropriate protective measures before
working on the pump (e.g. safety glasses, safety
gloves, ...). Adhere to the material safety data sheet
for the feed chemical.
– Drain and flush the liquid end before working on the
pump.
CAUTION!
Warning of feed chemical spraying around
Feed chemical can spray out of the hydraulic compo‐
nents if they are manipulated or opened due to pressure
in the liquid end and adjacent parts of the system.
– Disconnect the pump from the mains power supply
and ensure that it cannot be switched on again by
unauthorised persons.
– Depressurise the system before commencing any
work on hydraulic parts.
Troubleshooting
Ä 'Qualification of personnel'
Personnel
Technical
personnel
Electrician
89