Table of Contents
Advertisement
arp timeout seconds
//This command is used to set the aging time.
no arp timeout
//This command is used to cancel time Settings.
Parameter
Parameter
seconds
Default
None
Command Mode
Interface configuration mode
Example
//This command is to set up the ARP aging time for 3000 seconds.
switch(config)# interface vlanif1
switch(config-vlanif1)# arp timeout 3000
4.5
MSTP config
MSTP configuration commands include:
spanning-tree
spanning-tree mode
spanning-tree max-age
spanning-tree hello-time
spanning-tree forward-delay
spanning-tree max-hop
spanning-tree instance
show spanning-tree
show spanning-tree interface brief
Function Brief
STP is developed based on IEEE 802.1D, and is a protocol used to
eliminate physical loops at the data link layer in the LAN. STP-enabled
devices exchange information to detect loops on the network, and
selectively block some ports to change a loop topology into a loop-free tree
topology. This prevents continuous growing and infinite loop of packets on
the loop network, and prevents occurrence of problems such as degraded
packet processing capability of devices caused by repeated receiving of the
Parameters of the command mode
Unit
second, value range:60-86400.
:
Hide quick links:
Advertisement
Table of Contents
