3.1.2
speed
Command Description
speed {10 | 100 | 1000|10000|auto }
no speed
//It is used to set the port rate.
Parameter
parameter
10,100,1000,10000
auto
Default
By default, the speed mode is set to auto for an electric port,
10000M for a f-port fiber port
Command Mode
Interface configuration mode
Note:
Port speed of light is coerced into 1000M and 10000M.
Electricity mouth can only set auto, 10M and 100M
Example
// The port rate of G1 is set to 100M.
switch(config)# interface G1
switch(config-G1)# speed 100
3.1.3
flow-control
Command Description
//This command is used to enable or disable the flow control function of a
port.
Parameter
None
Default
The flow control function is enable by default
Command Mode
Interface configuration mode
Example
//enable the function.
switch(config-G1)# flowctrl
Parameters of the command mode
The port rate is set to 10M, 100M and 1000M.
The port rate is set to Auto.
flowctrl
no flowctrl