None
Default
Disable
Command Mode
Interface configuration mode
Example
switch(config)#interface G1
switch(config-G1)# lacp disable
3.4.4
lacp active | passive
Command Description
lacp active
lacp passive
//This command is used to configure the role of an LACP port.
//It specifies the role of a port, which is active or passive.
Parameter
None
Default
active
Command Mode
Interface configuration mode
Example
switch(config)#interface G1
switch(config-G1)# lacp active
3.4.5
lacp key
Command Description
aggregation port and determines whether the port can be added into
an aggregation port. LACP protocol generates an operation key
based on the port configuration (that is, the rate, duplex, basic
configuration and management key). Members of a dynamic
aggregation group can only be aggregated when they have the
same operation key.
Parameter
<1-65535>: The key value is manually specified. The value ranges
from 1 to 65535.
LACP key refers to the management key value of a dynamic