Dahua DH-PFS6428-24T Cli Configuration Manual page 75

//This command is set OSPF network attribute
Parameter
cost
network
priority
hello-interval
dead-interval
authentication
authentication
-key
Default
None
Command Mode
vlan configuration mode
Example
//This command is to modify the cost to 20.
switch(config)# interface vlanif2
switch(config-vlanif2)# ip ospf cost 20
//This command is to modify the network type of point-to-point.
switch(config)# interface vlanif2
switch(config-vlanif2)# ip ospf network point-to-point
//This command is to modify the interface priority for 254.
switch(config)# interface vlanif2
switch(config-vlanif2)# ip ospf priority 254
//Modify the effective interval of 30 seconds.
switch(config)# interface vlanif2
switch(config-vlanif2)# ip ospf hello-interval 30
//Modified failure interval time 300 seconds.
switch(config)# interface vlanif2
switch(config-vlanif2)# ip ospf dead-interval 300
//Modify the authentication type for MD5,The secret key for ABC
certification .
switch(config)# interface vlanif2
Cost value,you can
measure value of this interface to go out.
Network
type:point-to-point ,broadcast,non-broad
cast
Interface priority, broadcast multi access
network to make it a DR
Valid time interval
Invalid time interval
Authentication Type:MD5、SIMPLE
Key authentication
increase the