5.5.9 Redistribute; 5.5.10 Timer - Dahua DH-PFS6428-24T Cli Configuration Manual

5.5.9 redistribute

Command Description
redistribute <protocol> [metric <metric>] [route-map <route-map>]
no redistribute <protocol> [metric <metric>] [route-map <route-map>]
Parameter
Parameter
protocol
Metric
Route-map
Default
None
Command Mode
Interface configuration mode
Example
//The introduction of the direct route to RIP routing table, and through the
route-map rule "list123" rule, the metric value of the specified route is 9.
switch(config)# router rip
switch(config-rip)#redistribute connected metric 9 route-map list123

5.5.10 timer

Command Description
timers basic <update-interval> <dead-interval> <garbage-interval>
no timers basic
//Change the time interval of the RIP periodic update packets, RIP route
waiting time, RIP routing is set to not be used to completely remove the time
interval from the routing table.
Parameter
Parameter
Parameters of the command mode
The routing protocols that need to be
introduced into the RIP, such as IS-IS,
OSPF, BGP, static, connect, etc., are
introduced.
Specifies the metric value when the
route is introduced
Route-map name to be referenced
when the route is introduced
Parameters of the command mode