Lacp Port-Priority; Example - Dahua DH-PFS6428-24T Cli Configuration Manual

auto: The key value is automatically negotiated.
Default
auto
Command Mode
Interface configuration mode

Example

switch(config)# interface G1
switch(config-G1)# lacp key 100
3.4.6

lacp port-priority

Command Description
lacp port-priority <1-32768>
//This command is used to configure the priority of an LACP port.
Parameter
<1-32768>: It specifies the priority range. A smaller value indicates a
higher priority.
Default
0
Command Mode
Interface configuration mode
Example
switch(config)# interface G1
switch(config-G1)# lacp port-priority 100
3.4.7
example
The link aggregation is used to increase the bandwidth of device-level serial
ports and share loads based on the source/destination MAC address.
SW1/SW2:
switch# configure terminal