Table of Contents
Advertisement
timers
version
Function Brief
RIP is Interior Gateway Protocol that more common used and used earlier.It is
suitable for small and similar network,and it is a typical distance vector protocol.RIP
exchange routing information through broadcast UDP messages,and it is send
routing information update every 30 seconds.RIP provides count Hop (hop count) as
a scale to measure routing distance.The hop count is the number of routers that a
packet must pass to reach the target.If the same target has two different speed or
bandwidth of the router, but the same hop count.Then RIP thinks that the two route
is equal distance.RIP maximum support of the number of hops is 15,the number of
hops 16 indicates that it is not reachable.
5.5.1 default-information originate
Command Description
//default-information originate
no default-information originate
Parameter
None
Default
None
Command Mode
Interface configuration mode
Example
Switch(config)#default-information originate
//Start rip to generate the default rip route function.
5.5.2 default-metric
Command Description
default-metric XX
no default-metric XX
Parameter
Parameter
XX
Default
None
Parameters of the command mode
Default 1 ,range 1-16
Hide quick links:
Advertisement
Table of Contents
