Erps; Erps Xx - Dahua DH-PFS6428-24T Cli Configuration Manual

number of nodes on the ring network.
6.9.1

erps

Command Description
erps

erps xx(1-24)

Parameter
None
Default
disable
Command Mode
Global configuration mode
Example
Switch(config)# erps
6.9.2
erps xx
Command Description
erps xx erps groupprimary PORT(A) slave PORT(B) role master vid
VLAN wtr-time TIME guard-time GUARD-TIME
Parameter
Parameter
XX
PORT(A)
PORT(B)
VLAN
Wtr-TIME
GUARD-TIME
Default
None
Command Mode
Parameters of the command mode
1-24
any port
In addition to the above fill in the port
1-4094, Default 3001
1-12min ,When the RPL has a node that receives the first
R-APS (NR) message, the WTR timer is started.
100-2000ms,The default is 500ms, failure of adjacent
nodes to detect the fault recovery time to start the warning
time timer, so that the fault is connected to the port to
continue to maintain the blocking state