Restore Default Parameters (Obj. 1011H)]; [Restore Default Parameters (Obj. 1011H: 00H)]; [Restore All Default Parameters (Obj. 1011H: 01H)] - Mitsubishi Electric Melservo-J5 Series User Manual

2.7

[Restore default parameters (Obj. 1011h)]

[Restore default parameters (Obj. 1011h: 00h)]

Data Type Access
U8 RO
Description
The total number of Sub Index is returned. Supported Sub Index differ depending on the Network. The following shows the
Network and supported Sub Index.
Network Default
CC-Link IE TSN 01h

[Restore all default parameters (Obj. 1011h: 01h)]

Data Type Access
U32 RW
Description
All parameters (servo parameters and network parameters) that can be stored in the non-volatile memory can be reset to the
factory setting. To reset the servo parameters and network parameters to the factory setting, write "64616F6Ch" (= reverse
order of ASCII code of "load") in this object, and cycle the power or reset the software.
The read value is always "1" (initializing values).
2 General Objects
16
2.7 [Restore default parameters (Obj. 1011h)]
Mapping Default

Impossible
Range Description
01h (fixed) Sub Index 1 is supported.
Mapping Default
Impossible 00000001h
Range Units
 
Range Units

00000000h to
FFFFFFFFh
Save Parameter

Impossible
Save Parameter

Impossible