Flag Sdh - H3C S9500 Series Command Manual

Command Manual – Ethernet Interface
H3C S9500 Series Routing Switches

1.1.15 flag sdh

Syntax
flag { j0 | j1 } sdh value
undo flag { j0 | j1 } sdh
View
Ten-GigabitEthernet interface view
Default Level
2: System level
Parameters
j0: Sets the regenerator section trace byte.
j1: Sets the path trace byte.
value: Value for the J0 or J1 byte, a string of 1 to 15 characters.
Description
Use the flag sdh command to set the overhead byte (J0 or J1) of SDH frames when the
Ten-GigabitEthernet interface is working in WAN mode.
Use the undo flag command to restore the default.
By default, both J0 and J1 bytes are all zeros.
Related commands: port-mode.
Note:
This command can take effect only when the Ten-GigabitEthernet interface is
operating in WAN mode.
Examples
# Set the J0 byte in SDH frames to Sysname on ten-GigabitEthernet 1/1/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/1
[Sysname-Ten-GigabitEthernet1/1/1] port-mode wan
[Sysname-Ten-GigabitEthernet1/1/1] flag j0 sdh Sysname
Chapter 1 Ethernet Interface Configuration Commands
1-23