Obstruction And Reversing Parameters - Siemens SIDOOR AT40 System Manual

6.7.3.5

Obstruction and reversing parameters

Table 6- 41 Obstruction and reversing parameters (general)
Parameter ID Adjustment range
General
p3850 Bit x = 1 ≙ function
1)
activated
Bit x = 0 ≙ function
deactivated
Expert parameters, see Section Expert configuration (Page 64).
1)
The parameters in the table below refer to the closing direction only.
Table 6- 42 Obstruction and reversing parameters (in the closing direction)
Parameter ID Adjustment range
Timing
p3852 0 ... 60000
1)
p3853 0 ... 60000
1)
p3854 0 ... 60000
1)
Ranges
p3855 0 ... 60000
1)
p3856 0 ... 60000
1)
p3857 0 ... 60000
1)
p3858 0 ... 60000
1)
p3859 0 ... 60000
1)
Retries
AT40, ATD400V, ATD400K, ATD4xxW, ATD400S, ATE250S, ATD400T
System Manual, 06/2016, A2B00096162-AN
Factory Unit
setting
0x00FF —
Factory set- Unit
ting
1000 ms
300 ms
100 ms
20 mm
10 mm
10 mm
20 mm
50 mm
Description
Function control
Bit 0 ≙ stop obstruction detection in the closing di-
rection
Bit 1 ≙ force obstruction detection in the closing
direction
Bit 2 ≙ obstruction counter in the closing direction
Bit 3 ≙ slow obstruction approach in the closing
direction
Bit 4 ≙ stop obstruction detection in the opening
direction
Bit 5 ≙ force obstruction detection in the opening
direction
Bit 6 ≙ obstruction counter in the opening direction
Bit 7 ≙ slow obstruction approach in the opening
direction
Description
ON-delay time for obstruction detection
Minimum detection time for stop obstruction
Minimum detection time for force obstruction
Distance for slow obstruction approach before and
after the obstruction
Range of suppression of obstruction detection
before the closed end stop
Range of suppression of obstruction detection
after the open end stop
Range of suppression of force obstruction detec-
tion before the creep distance
Range of suppression of force obstruction detec-
tion after the last obstruction
Controllers
6.7 Parameters
177