Operation And Parameter Assignment - Siemens SIDOOR AT40 System Manual

6.4

Operation and parameter assignment

The service buttons can be used to operate the controller.
The following options are available to parameterize the controller.
1. Parameter assignment with the minimal editor (not for ATE250S and ATD4xxW)
2. Parameter assignment with the terminal module
3. Parameter assignment with additional units (SIDOOR Service Tool, SIDOOR Software
Kit)
Note
After the optimal parameter settings have been determined, note them in the configuration
record (see Appendix Configuration record (Page 326)). Have this record to hand when you
call the Hotline.
Note
Parameter changes
Parameters should always be adjusted during normal operation with the door in the
CLOSED position, because the controller then accepts the values immediately.
AT40, ATD400V, ATD400K, ATD4xxW, ATD400S, ATE250S, ATD400T
System Manual, 06/2016, A2B00096162-AN
6.4 Operation and parameter assignment
Controllers
109