Tzw2 - Technology Status Word 2 - Siemens SIDOOR AT40 System Manual

Controllers
6.11 Structure of user data/process data
6.11.2.8

TZW2 - Technology status word 2

Table 6- 86
Reserved
IMPDRVIncr and IMPDRVVelo signals
The signals IMPDRVIncr and IMPDRVVelo are in the low byte of TZW2 (bits 0 to 2, and
bits 3 to 5). Both have a numeric structure.
Table 6- 87
IMPDRVIncr
signal value
0
1
2
8
Table 6- 88
IMPDRVVelo
signal value
0
1
2
8
Note
The IMPDRVIncr and IMPDRVVelo signals as well as the lead time are reset on the
transition of the sequential control system to the "S4: Z_operation" (see Image 6-33
Sequential control state graph (Page 216)) state. This decouples the ImpDrv signals from the
service mode (local operation) and operating mode.
You will find further information about the IMPDRVIncr and IMPDRVVelo signals and the
corresponding drive function in Section ImpulseDrive (Page 65).
212
Technology status word 2 (TZW2)
15 ... 11 10 ... 9
ASStp
IMPDRVIncr signal
Name
ImpDrvInaktiv
ImpDrvOpen
ImpDrvClose
Reserved
IMPDRVVelo signal
Name
ImpDrvInaktiv
ImpDrvOpen
ImpDrvClose
Reserved
TZW2
8 7 ... 6
ASDRV Reserved
Description
No ImpDrv detected or inactive
tion)
ImpDrv is detected in the opening direction
dependent detection)
ImpDrv is detected in the closing direction
dependent detection)
...
Description
No ImpDrv detected or inactive
ImpDrv is detected in the opening direction
dependent detection)
ImpDrv is detected in the closing direction
detection)
...
AT40, ATD400V, ATD400K, ATD4xxW, ATD400S, ATE250S, ATD400T
System Manual, 06/2016, A2B00096162-AN
5 ... 3 2 ... 0
IMPDRVVelo IMPDRVIncr
(distance-dependent detec-
(distance-
(distance-
(speed-dependent detection)
(speed-
(speed-dependent