Error Messages - Silca Unocode 399 Plus Operating Manual

Unocode 399 PLUS
5.11.2 E
RROR MESSAGES
• The a utomatic sett ing revealed a vari ation that e xceeded the permitted no minal figure setting
reference. Carefully repeat the setting procedure.
• During the setting of the "machine's zero points" there is a contact failure between the two templates
(see chap.5.8.7, page 46).
• This message indicates that during the r eading cycle an anomalous form has been revealed that
cannot be reproduced with the cutters provided.
• The Machine ID has not been set. In such cases access cannot be gained to Protected Systems until
the Machine ID is set. Select menu 5.10 "ENABLING"and check that the Machine ID is different from
0. To set M achine ID ask for a Software update valid for yo ur machine and install with the S ILCA
WinTransfer Program or SILCA Code Program.
58
ERROR 3
Exceeded setting
tolerance limit
See operating manual
ERROR 4
No template
contact made.
See operating manual
ERROR 5
Key cannot be
copied
ERROR 6
Machine ID
not defined
See operating manual
Copyright S ilca 2010
Operating manual - English