Imited Access To Ata Protected Systems - Silca Unocode 399 Plus Operating Manual

Unocode 399 PLUS
5.4.2 L
IMITED ACCESS TO
Silca has limited access to some of the data in the Database in agreement with certain manufacturers.
Limitations are applied to:
- DATA CARD, if the key-cutting card is protected, access is denied.
To access protected data:
a) apply to the manufacturer for authorization.
b) communicate to Silca:
- cutting machine SERIAL NUMBER
- cutting machine ID
- the ACTIVATION CODE
Silca will issue a Password to enter in order to enable
cutting of the protected system.
When a protected data card is selected from the F1
menu (e.g.: 2211) the following screen will appear:
When the man ufacturer's au thorization h as be en
given, contact SIL CA to be issue d a password,
providing the following information:
- Machine serial No XXXXXXXXXXXXX
Read the seri al nu mber on th e ID pla te located on
the back of the key-cutting machine or on the in itial
display.
- Machine ID XXXXX
Can be se en i n the b ox used to ap ply for the
password.
- ACTIVATION Code XXXXXXXXXX
ONLY shown when access is tried to protected data.
Enter the password issued by Silca into the relevant
field.
If th e password entered is correct, th e fo llowing
screen will appear:
• The password can be saved (with ENTER) so that
it will not be necessary to enter it again when using
the protected data card.
• Press STOP if you
password in the machine memory. In any case the
choice made is en abled for the
progress.
The password will be required again for future ac-
cess to the data card.
PROTECTED DATA CARD ENABLING PROCEDURE
1) Enter the data card number.
2) Press ENTER.
3) Enter the Password.
4) Press ENTER.
5) Press ENTER again to confirm.
32
D (
ATA PROTECTED SYSTEMS
don't wan t to save the
operation in
Copyright S ilca 2010
Operating manual - English
)