Silca Unocode 399 Plus Operating Manual page 31

Operating manual - English
d) Data Card Parameters
Function used to
relating to the data card.
• Press 4.
• Press 1.
• Press STOP to exit.
(*) With the measuring un it set on millimetres the hi ghlighted measure ments are e xpressed in
hundredths of a millimetre.
view the tech nical data
F
F
Key blank measurements *
Cutting angle
Symbols associated to cutting depths *
Cutting spaces *
Measuring unit
Base of the cuts *
Copyright S ilca 2010
F4
F1
Key stop
Unocode 399 PLUS
27