Silca Unocode 399 Plus Operating Manual page 79

Operating manual - English
7.13 WIN-TRANSFER P
PROGRAM
The machine is supplied with an intern al program already loaded and tested in our workshops. The user
therefore does not need to carry out any operations.
Only in the situations described below can the WIN-TRANSFER program be used to re-start the machine.
The following is a list of situations where the use of the WIN-TRANSFER program is required.
• Replacement of the electronic board (see chap. 7.6, page 68) or loss of the
internal machine program.
1) replace the board with a new one, if necessary.
2) install on your personal computer the latest version received of the WinTransfer program.
3) read the serial number on the data plate on the back of the machine (ch.5.9, page 52) and enter on the
machine.
4) gauge the machine according to the instructions in the manual, as follows:
- gauge as expl ained i n cha pter 5.8.7 "MACHINE ZERO POINTS" and chap.5.7.1 "Calibrate
STANDARD JAWS"" in the user's manual.
- first gauge the V100 clamp (chap. 5.7.1, page 41).
- continue with the gauging of remaining jaws used.
At this point the machine is set up and ready for operation.
• SILCA update for the program or machine data
1) Install the WinTransfer Program update on your personal computer, following the instructions in the
program.
ROGRAM FOR LOADING
Copyright S ilca 2010
Unocode 399 PLUS
/
UPDATING THE INTERNAL MACHINE
75