Silca Unocode 399 Plus Operating Manual page 52

Unocode 399 PLUS
Press START, the display will show:
Press ENTER to confirm,
parameters were ON (***).
Press ST OP to cance l th e ope ration an d not
confirm the adjustments made (if there is one value
or more on OFF). The previous values remain valid
(already in the machine's memory).
ATTENTION: if the STOP key is pressed, the new
settings will be lost. If so, only the previous setting
values will remain valid.
(**) If th e te mplates have no
positioned the following ERROR message appears:
(***) If one or both the photocells or one or both the sensors are OFF, repeat the operation following
the procedure described in chap. 5.8.8, page 49.
48
only if the previ ous
t be en prop erly
Copyright S ilca 2010
Operating manual - English