Cable Connections; Ethernet Cable Specifications - ProSoft MVI56E-MCMR User Manual

MVI56E-MCMR ♦ ControlLogix Platform
Modbus Communication Module with Reduced Data Block
6.4

Cable Connections

The application ports on the MVI56E-MCMR module support RS-232, RS-422,
and RS-485 interfaces. Please inspect the module to ensure that the jumpers are
set correctly to correspond with the type of interface you are using.
Note: When using RS-232 with radio modem applications, some radios or modems require
hardware handshaking (control and monitoring of modem signal lines). Enable this in the
configuration of the module by setting the UseCTS parameter to 1.

6.4.1 Ethernet Cable Specifications

The recommended cable is Category 5 or better. A Category 5 cable has four
twisted pairs of wires, which are color-coded and cannot be swapped. The
module uses only two of the four pairs.
The Ethernet ports on the module are Auto-Sensing. You can use either a
standard Ethernet straight-through cable or a crossover cable when connecting
the module to an Ethernet hub, a 10/100 Base-T Ethernet switch, or directly to a
PC. The module will detect the cable type and use the appropriate pins to send
and receive Ethernet signals.
Ethernet cabling is like U.S. telephone cables, except that it has eight
conductors. Some hubs have one input that can accept either a straight-through
or crossover cable, depending on a switch position. In this case, you must ensure
that the switch position and cable type agree.
Refer to Ethernet cable configuration (page 170) for a diagram of how to
configure Ethernet cable.
ProSoft Technology, Inc.
Reference
User Manual
Page 169 of 223