Table of Contents
Advertisement
Configure Connect IT using the web user interface
Setting
Management priority
MTU
Active recovery
6. Click Save.
Configure an IPv6 network interface for the modem
You can configure an IPv6 network interface.
1.
Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the Modem section.
4. Expand the IPv6 section.
5. Configure the settings.
Setting
Enable
Digi Connect IT® 16/48 User Guide
Description
The management priority assigned to this interface.
An interface that is up and has the highest
management priority will have its address reported
as the preferred contact address for central
management and direct device access.
Default: 0
Minimum: 0
Maximum: 1000
Specify a desirable Maximum Transmission Unit
(MTU) for this interface. If this is a non-static (DHCP)
interface, the lower MTU value of the one offered by
the DHCP and the one specified will be in effect.
Default: 1500
Minimum: 576
Maximum: 65535
Active recovery performs regular network tests to
determine if working connections can be made to
remote targets. The network tests available are ping
tests, HTTP/HTTPS tests, and DNS tests. This
interface's default route will be disabled when the
connectivity tests fail, allowing other interfaces with
lower metrics to take precedence.
UI.
Description
Select Enable to enable an IPv4 network interface.
Configure the modem in the Connect IT
43
Advertisement
Table of Contents
