Table of Contents
Advertisement
Hardware
Item
Name
3
ETH2
4
ETH1
SFP1
5
SFP2
6
Console port
7
USB ports
Digi Connect IT® 16/48 User Guide
Description
Indicates the status of the backup connection on the LAN.
ETH2 is configured for LAN/DHCP server.
See
Connect hardware and connect to site network using an
Ethernet
LAN.
The LED indicates the connection status:
Flashing: The unit is attempting to establish a backup
n
connection on the LAN.
Solid: A backup network connection has been established
n
on the LAN.
Indicates connection to Ethernet WAN network.
ETH1 is configure for WAN/DHCP client.
Connect an SFP+ module to the Connect IT.
SFP1: Enabled for WAN\DHCP client. SFP1 is the bottom
n
slot.
SFP2: Enabled for LAN\DHCP server. SFP2 is the top slot.
n
Note
When you use an SFP+ module, you cannot use the equivalent
Ethernet port. For example, if you insert an SFP+ module into the
SFP1 slot, you cannot use the ETH1 slot. If you insert an SFP+
module into the SFP2 slot, you cannot use the ETH2 slot.
The LED indicates the connection status.
Green: The LED lights green:
n
10 Gb/s: constant light
o
1 Gb/s: OFF light
o
ACT: The LED is green.
n
A console adapter accessory can be used with a straight through
RJ45 cable to connect a serial port on a computer to the console
port of the Connect IT.
Left: The left LED for a port lights yellow.
n
Right: The right LED for a port lights green.
n
Behaviors: ON, OFF, slow blink, fast blink.
Connect a USB flash drive to the Connect IT for backup or logging.
Front panel and LEDs
59
Advertisement
Table of Contents
