Enable A Tcp Connection On The Serial Port - Digi Connect IT 16 User Manual

Configure Connect IT using the web user interface
5. Expand the Telnet connection section.
6. Configure the settings.
Setting
Enable
Port
7. Specify the addresses, interfaces, and firewall zones which are allowed to access the serial
port. Expand the Access control list.
Setting
IPv4 Addresses
IPv6 Addresses
Interfaces
Zones
8. Click Save.

Enable a TCP connection on the serial port

You can enable a TCP connection on the serial port.
1. Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the Serial section.
4. Expand the port that you want to configure: Port 1, Port 2, Port 3, or Port 4.
Digi Connect IT® 16/48 User Guide
Description
Select the Enable option to allow the serial port to be directly
accessed by a Telnet connection.
WARNING! This connection is not authenticated
or encrypted.
Specify the Telnet port for the service.
Minimum value: 1
Maximum value: 65535
Default: 2001
Description
Expand the IPv4 Addresses section to add IPv4 addresses or
networks from which this serial port can be accessed. Click
Add to add an address.
Expand the IPv6 Addresses section to add IPv6 addresses or
networks from which this serial port can be accessed. Click
Add to add an address.
Expand the Interfaces section to add network interfaces from
which this serial port can be accessed. Click Add to add an
interface.
Expand the Zones section to add firewall zones from which
this serial port can be accessed. Click Add to add a zone.
UI.
Configure a serial port
34