Digi Connect IT 16 User Manual page 32

Configure Connect IT using the web user interface
3. Expand the Serial section.
4. Expand the port that you want to configure.
5. Configure the settings.
Setting
Enable
Serial mode
Label
Baud rate
Data bits
Parity
Stop bits
Flow control
Escape sequence
Digi Connect IT® 16/48 User Guide
Description
Select the Enable option to enable this port for use. If it is not
selected, the port won't work.
Select an access mode for this serial port.
Login: Select this option to display the Login Manger
n
screen when you access the web UI.
Remote access: Select this option to allow OOB
n
management. This is the default.
The name of the serial port. If left blank, the default label is
used.
An entry is optional.
The baud rate for the serial port. This value must match the
baud rate configuration for the equipment connected to the
Connect IT.
The default is 9600.
The number of data bits for the serial port. This value must
match the data bits configuration for the equipment
connected to the Connect IT.
The default is 8.
The type of parity bit for the serial port. This value must match
the parity bit configuration for the equipment connected to
the Connect IT.
The default selection is NONE.
The number of stop bits for the serial port. This value must
match the stop bits configuration for the equipment
connected to the Connect IT.
The default is 1.
The type of flow control for the serial port. This value must
match the flow control configuration for the equipment
connected to the Connect IT.
The default selection is NONE.
The sequence of characters used to start an escape sequence.
Escape sequences allow a user to send control commands to
the serial port interface. These commands are removed from
the data stream and are not sent to the equipment connected
to the serial port.
If left blank, the escape sequence is disabled.
The default is a tilde (~).
An entry is optional.
Configure a serial port
32