Table of Contents
Advertisement
Configure Connect IT using the web user interface
4. Expand the Modem section.
5. In the Add APN field, enter the custom APN.
6. Click Add.
7. If the custom APN requires a specific user name and password, enter them in the Username
and Password fields.
8. Click Save.
Configure an IP passthrough for the modem
You can configure an IP passthrough. This is used to assign the address obtained from the cellular
network to an external device using DHCP, rather than assigning it to the modem device in this
Connect IT.
1.
Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the Modem section.
4. Expand the Passthrough section.
5. Configure the settings.
Setting
Enable
Device
Zone
Packet filtering
Digi Connect IT® 16/48 User Guide
UI.
Description
Select Enable to enable IP passthrough for this
network interface.
The network device that the external device is
connected to. The address from the cellular network
will be assigned to the external device via DHCP,
rather than being assigned to the modem device in
this unit.
Options are: Loopback, LAN, or WAN.
The firewall zone assigned to the passthrough
network interface. This can be used by packet
filtering rules and access control lists to restrict
network traffic on the passthrough interface.
Options are: Any, Loopback, Internal, External,
Setup, IPsec, Dynamic routes.
Enable firewall packet filtering rules for the
passthrough network traffic.
If this setting is disabled, then network traffic is
allowed in both directions, and it is the responsibility
of the external device to provide its own firewall.
Configure the modem in the Connect IT
40
Advertisement
Table of Contents
