Installing The Ac Drive In An It System, Mr7 - Danfoss VACON 100 INDUSTRIAL Operating Manual

Operating Guide | VACON® 100 Wall-mounted Drives
3. For MR4 and MR5, attach the cable cover.
4. Close the cover of the AC drive.
5. After the change, write "The EMC level was changed" and the date on the "product modified" label. If the label is not yet attached,
attach it on the drive near the nameplate.
Product modified

6.6.2 Installing the AC drive in an IT System, MR7

Context:
Use these instructions to change the EMC protection of the AC drive to level C4.
Prerequisites:
Open the cover of the AC drive and remove the cable cover (for 600/690 V) as instructed in
for MR4-MR7.
Danfoss A/S © 2019.05
Date:
Date:
Date:
Electrical Installation
6.4.1 Get Access and Locate the Terminals
AQ298036140958en-000101 / DPD01711| 55