Operating Guide | VACON® 100 Wall-mounted Drives
M4x16
(2.2 Nm)
7. Put the cable entry plate with the cables into the groove on the frame of the drive.
8. Connect the cables. See the correct tightening torques in
A Expose the shield of all the 3 cables to make a 360-degree connection with the grounding clamps for cable shield.
B Connect the phase conductors of the mains cable and of the motor cable, and the conductors of the brake resistor cable into
the correct terminals.
C Attach the grounding conductor of each cable to a grounding terminal with a grounding clamp for grounding conductor.
D Make sure that the external grounding conductor is connected to the grounding bar. See
46 | Danfoss A/S © 2019.05
10.5 Tightening Torques of the
Electrical Installation
Terminals.
6.3
Grounding.
AQ298036140958en-000101 / DPD01711