Danfoss VACON 100 INDUSTRIAL Operating Manual page 77

Operating Guide | VACON® 100 Wall-mounted Drives
A Do not cut the grommet openings wider than what is necessary for the used cables.
B If the grommet folds in when putting the cable, pull the cable back to make the grommet straight.
C Pull the first bit of the cable out of the grommet so that it stays straight. If this is not possible, make the connection tight with
some insulation tape or a cable tie.
4. Put the cover of the drive back. Pull the fieldbus cables away from other cables.
A
A Ethernet cable
Illustration 34:
Danfoss A/S © 2019.05
Routing the Ethernet Cables in IP21
Control Unit
AQ298036140958en-000101 / DPD01711| 77