Figure 2 Assembly Of The Mounting Stand - Vaisala Optimus OPT100 Installation Manual

Figure 2 Assembly of the Mounting Stand
1 Mounting holes on the top are for attaching the DGA monitor.
2 Mounting holes on the side join the parts of the mounting stand together.
3 Holes on the bottom (three on each side) are for anchoring the mounting stand to the
ground.
4 Attach the power supply unit to the middle part using these four holes.
1. Assemble the mounting stand. Tighten the screws to finger tightness at this point, not all
the way.
4
Chapter 3 – Mechanical Installation
1
2
3
17