Configuring Dnp3 Protocol; Figure 25 Dnp3 Settings Page - Vaisala Optimus OPT100 Installation Manual

OPT100 Installation Guide
5.10 Configuring DNP3 Protocol
Figure 25 DNP3 Settings Page
DNP3 protocol is an optional feature and requires a license. If a license is not
installed on the DGA monitor, you cannot enable the protocol. Contact Vaisala for
acquiring the license.
1. In the user interface, select Settings > Network > DNP3.
2. Select if the DNP3 protocol should be Enabled or Disabled.
3. If you enabled the DNP3 protocol, set the DNP3 Link Address you want to use on this
DGA monitor.
4. Select Apply to save your changes.
Select Download to download the DGA monitor device profile in XML format. It is
needed to configure your DNP3 master system.
56
M211857EN-F