Mounting With Wall Mounting Set - Vaisala Optimus OPT100 Installation Manual

3.3 Mounting with Wall Mounting Set
• Wall Mounting Set (Vaisala item OPTMSET1)
• Installation beam (2 pcs)
• Cradle for Power Supply Unit
• Screws and washers
• 6 mm hex key
1. Attach one of the installation beams to the mounting location, at a height where you want
the top of the OPT100 enclosure to be. Make sure it is securely attached from at least two
points, and can bear the full weight of the DGA monitor.
2. Attach the second installation beam at the height of the second set of mounting holes.
3. Attach screws with washers to the top mounting holes of each pair on the sides of the
OPT100 enclosure (four screws in total). Tighten them enough to safely bear the weight of
the enclosure but not all the way in. The second hole of each set must remain free at this
point.
4. With two people lifting, lift the OPT100 enclosure up and hang it from installation beams
by the screws. If the lower installation beam is not at the correct height, re-attach it at the
correct height before attempting this step again.
5. Tighten the four screws to secure the enclosure in place.
6. Add a second screw (with washer) below each of the installed screws, and tighten them.
The enclosure is now secured to the installation beams by a total of eight screws.
Chapter 3 – Mechanical Installation
1 Installation beam mounting screws.
2 Leave second set of mounting holes
free for weather shield installation.
1
2
21