SEW-Eurodrive DFE32B PROFINET IO Manual page 35

Starting the con- Load the project planning in the SIMATIC S7 and start the module. The Error LED of the
troller controller should now go out.
The LEDs of the DFE32B option should have the following statuses:
•
•
•
If this is not the case, check the project planning, especially the device name and the IP
address of the node.
Project planning This example is to show the positioning of the drive via MOVIDRIVE
example for the positioning via bus" application module can be used.
process data con-
The information between PLC and inverter is exchanged via 6 process data words.
figuration of
®
MOVIDRIVE B
The following figure shows the corresponding PROFINET parameterization.
Manual – DFE32B Fieldbus Interface PROFINET IO
Project Planning with PROFINET
Project planning for the PROFINET IO controller
RUN LED: lights up green
BUS FAULT LED: off
Link/Activity LED: Flickering
IO controller:
e.g. PLC
De - - Beschleu- Beschleu- Beschleu- Accelera -
celeration nigung nigung nigung tion
Status – Status – Status – Status Actual Ist – Ist – Ist –
Wort Wort Wort position position position position
word
Outputs
Inputs
6 process output data
Soll- Soll- Soll- Ziel- Ziel- Ziel-
Target
Setpoint
drehzahl drehzahl drehzahl position position position
speed position
Actual Ist – Ist – Ist – Actual Ist – Ist – Ist –
position position position position drehzahl drehzahl speed drehzahl
6 process input data
®
B. The "Extended
IO device:
e.g. drive inverter
Ziel- Ziel- T - Control Control Control Control
Target
position position position position Wort word Wort Wort
Output –
Unit
Ausgangs – Ausgangs – Ausgangs – Geräte – Geräte – Geräte –
strom strom strom auslastung auslastung auslastung utilization
current
62347AEN
68073AEN
5
35