Table of Contents
Advertisement
Adjusting located
Proceed as follows to adjust (address) the localized Ethernet nodes to the network:
Ethernet nodes to
1. Double-click in the "Communication parameters" area of the respective unit [1].
the network
(address)
[1]
[2]
2. Transmit the address changes to the Ethernet node. Click on [Download] [2].
3. Switch the unit off and on again in order to apply the changes.
Manual – DFE32B Fieldbus Interface PROFINET IO
MOVITOOLS® MotionStudio – Operation
"Communication parameters" window
[Download] button
You can now change the following settings:
•
IP address of the Ethernet node
•
IP address of the subnet mask
•
IP address of the standard gateway
•
DHCP startup configuration (if supported by the unit)
Communication via Ethernet
9
64349AXX
115
- Quick Links:
- Installing the Dfe32B/Uoh11B Gateway
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DFE32B PROFINET IO and is the answer not in the manual?
Questions and answers
Bus fault
Common causes of a bus fault in SEW-Eurodrive DFE32B PROFINET IO include:
1. No connection between the inverter and Ethernet.
2. PROFINET IO controller is switched off or not started.
3. Mismatch between the PROFINET device name in the project and the inverter.
4. Incorrect or missing configuration of the DFE32B option (wrong device name or IP address).
5. Faulty or incorrect bus cabling.
6. Incorrect unit type or configuration used in project planning.
This answer is automatically generated