SEW-Eurodrive DFE32B PROFINET IO Manual page 116

MOVITOOLS® MotionStudio – Operation
9
Communication via Ethernet
Adjusting the
engineering PC to
the network
(address)
116
To the following to adapt the engineering PC to the network setting (addressing):
1. Select the following item from the Windows start menu:
[Start] / [Setup] / [Network connections]
2. Select the corresponding PC interface.
3. Select "Properties" from the context menu.
4. Activate the checkbox with the entry "Internet protocol (TCP/IP)".
5. Click on the [Properties] button.
6. Activate the "Use the following IP address" checkbox.
7. For the subnetwork mask and standard gateway, enter the same IP addresses that
are used for other Ethernet nodes in this local network.
8. For the engineering PC, enter an IP address that meets the following conditions:
• In the blocks that define the network, the address segment for the engineering
PC must correspond to the other Ethernet nodes.
• In the blocks that define the node, the address segment for the engineering PC
must differ from the other stations.
• The last block must not contain the values "0", "4", "127" or "255".
NOTE: In the IP address of the subnet mask (such as 255.255.255.0), the values
in the blocks have the following meaning:
– "255", defines the address of the network where the nodes are located.
– "0", defines the address of the actual node to distinguish it from other nodes.
Manual – DFE32B Fieldbus Interface PROFINET IO