Communication Via Ethernet; Address Editor - SEW-Eurodrive DFE32B PROFINET IO Manual

9.9

Communication via Ethernet

9.9.1

Address Editor

Overview The Address Editor is a freeware tool by SEW-EURODRIVE GmbH & Co KG.
It is available once the "MOVITOOLS
However, it is used separately.
You can use the Address Editor to establish a communication for your units via Ethernet
and to address the units.
If you use a patch cable to connect the Ethernet interface of your engineering PC to the
Ethernet, the Address Editor detects all Ethernet nodes in the connected network seg-
ment (local network).
Unlike with "MOVITOOLS
the engineering PC to the local network.
This means the Address Editor is a useful addition to "MOVITOOLS
Proceed as follows if you have added other Ethernet nodes to an existing network:
•
•
Once you have found the added Ethernet nodes, you have two options:
•
•
Opening the You can use the Address Editor once MOVITOOLS
Address Editor
Do the following to start the Address Editor:
1. Close MOVITOOLS
2. Start the Address Editor from the Windows start menu via:
Manual – DFE32B Fieldbus Interface PROFINET IO
MOVITOOLS® MotionStudio – Operation
®
MotionStudio", you will not have to adjust the IP address of
Start the Address Editor
Search for Ethernet nodes
Setting the detected Ethernet nodes according to the network (addressing)
Setting the engineering PC according to the network (address)
®
MotionStudio.
[Start] / [Programs] / [SEW] / MOVITOOLS MotionStudio] / [Address Editor
(Address Tool)]
Communication via Ethernet
®
MotionStudio" engineering software is installed.
®
MotionStudio has been installed.
9
®
MotionStudio".
113