Procedure After A Replacement; Movidrive ® B Unit Replacement; Movitrac ® B/Gateway Unit Replacement - SEW-Eurodrive DFE32B PROFINET IO Manual

4.9

Procedure after a replacement

®
4.9.1 MOVIDRIVE B unit replacement
If you insert the memory card of the replaced MOVIDRIVE
B, the new unit is recognized by the PROFINET IO controller without any additional
measures.
INFORMATION
If you do not install the memory card of the replaced MOVIDRIVE
MOVIDRIVE
to load the saved parameter set into the new MOVIDRIVE
the PROFINET IO unit name again using the project planning software. Proceed as
with an initial startup (→ section "Project Planning with PROFINET").
There are no measures required if only the DFE32B option is replaced.
®
4.9.2 MOVITRAC B/gateway unit replacement
•
•
•
•
Manual – DFE32B Fieldbus Interface PROFINET IO
Assembly and Installation Notes
®
B, you have to perform a complete startup of the inverter or you have
Only for device replacement MOVITRAC
the saved parameter set into the new MOVITRAC
plete startup of the inverter (→ MOVITRAC
You have to set the PROFINET IO unit name again using the project planning soft-
ware. Proceed as with an initial startup (→ section "Project Planning with
PROFINET").
Prior to the auto setup, check the parameters P884 SBus Baud Rate and P831
Fieldbus Timeout response. The baud rate of the devices connected to the SBus has
to correspond to the baud rate of the gateway (DFE32B). Use the parameter tree of
the gateway in MOVITOOLS
Now activate the auto setup function. Set the "AS" DIP switch on the DFE32B option
to 1.
Procedure after a replacement
®
B with fieldbus option: You have to load
®
B, or you have to perform a com-
®
B operating instructions).
®
MotionStudio.
®
B in the new MOVIDRIVE
®
B in the new
®
B. Further, you have to set
4
®
25