Configuring The Communication Via Sbus - SEW-Eurodrive DFE32B PROFINET IO Manual

Proceed as follows to connect the USB-CAN interface with the PC and your unit:
1. Connect the 9-pin D-sub connector of the USB-CAN interface with the prefabricated
2. Connect the second cable end (without terminating resistor) with the SBus interface
Signal
CAN_H
CAN_L
CAN_GND
3. If the unit is operated within a CAN network, connect the terminating resistor at the
4. Plug the USB-A connector of the USB cable into a free USB interface on your PC [1].
For detailed information about the startup of a USB-CAN interface in connection with a
MOVIAXIS
structions.
9.8.3

Configuring the communication via SBus

You need an SBus connection between your PC and the units you want to configure.
You can use a USB-CAN interface for this purpose.
Proceed as follows to configure SBus communication:
1. Click on "Configure communication plugs" [1] in the toolbar.
Manual – DFE32B Fieldbus Interface PROFINET IO
MOVITOOLS® MotionStudio – Operation
Communication SBus (CAN) via interface adapter
connection cable. Make sure that the cable end with the terminating resistor leads to
the USB-CAN interface.
[3] of the unit [4].
®
• If MOVIDRIVE is equipped with the DFC11B connection option, you can con-
nect the D-sub plug of the prefabricated cable directly with terminal X30.
• Without the connection option, connect the cores of the prefabricated cable to the
X12 terminal of MOVIDRIVE
Terminal on
MOVIDRIVE
X12:2
X12:3
X12:1
last unit.
®
unit, refer to the "MOVIAXIS
[1] "Configure communication plugs" symbol
®
as follows:
CAN pin assignment
®
(9-pin D-sub connector)
PIN 7
PIN 2
PIN 3
®
MX Multi-Axis Servo Inverter" operating in-
9
Core
(Deviations are pos-
sible)
Brown
White
Shielding
[1]
68062AXX
109