MICRO-EPSILON colorSENSOR CFO Series Instruction Manual page 60

Operation
Direct connection to PC, controller with static IP
(factory setting)
PC with static IP
Connect the controller to the PC using a direct Ethernet con-
nection (LAN). For this purpose the cable: CAB-M12-4P-St-
ge;Xm-PUR-Cat5e;RJ45-Eth.
Start a web browser.
Click the task bar and enter the static address for the sen-
sor.
i
In the delivery state, this is 169.254.168.150.
• Address type: static IP address
• IP address: 169.254.168.150
• Subnet mask: 255.255.0.0
This IP address can be adapted on the web site under Set-
tings > Ethernet settings.
i
After changing the IP address, please note the new IP ad-
dress, to find the sensor again later.
1) This assumes that the LAN connection on the PC uses the
following IP address, for example: 169.254.168.1.
The interactive web sites for setting the controller and peripheral devices then appear in the web browser.
colorSENSOR CFO
1
Network
Controller with dynamic IP , PC with DHCP
Connect the controller to a switch using a direct Ethernet
connection (LAN). For this purpose the cable: CAB-M12-
4P-St-ge;Xm-PUR-Cat5e;RJ45-Eth
Enter the controller in the DHCP / register the sensor with
your IT department.
Your DHCP server assigns an IP address to your controller. You
can request this IP address from your IT department.
Start a web browser.
Click the task bar and enter the sensor IP address you
received from your IT department.
Alternative: When using DHCP with the DHCP server coupled to
the DNS server, access to the controller is possible using a host
name with the structure "CFO-<Serial number>".
Start a web browser on your PC. To reach a CFO100 with
the serial number "7454229522", enter "CFO-7454229522"
in the web browser address line.
Page 60