Automatic Level Adjustment - MICRO-EPSILON colorSENSOR CFO Series Instruction Manual

Operation
5.4.1.1
The automatic level adjustment determines a suitable combination of internal sensor parameters for the cur-
rent optical situation. The primary factor here is the level setting for the illumination LED:
colorSENSOR CFO

Automatic Level Adjustment

This starts an automatic level setting process
INT
TEACH
AUTO i
CLR
OPT
GATE 1
TEACH 2
HOLD 3
ESC
MULTI 4
TOL
CLASSIFY 5
SPHERE 6
7
CYLINDER
BOX 8
The automatic level adjustment process requires several seconds. During this
time, output LEDs 1 - 8 flash alternately, i.e. the even numbered LEDs and the
INT
TEACH
uneven numbered LEDs flash on and off together in groups.
AUTO
i
CLR OPT
GATE 1
TEACH 2
HOLD 3
ESC
MULTI 4
TOL
CLASSIFY 5
SPHERE 6
CYLINDER 7
BOX 8
Press the AUTO key for less than 2 sec.
The level for the sensor parameters should be set for the brightest color to
be tested.
The automatic level adjustment sets the photo receiver to 80 % saturation.
Page 38