Chapter 4 Introduction To Configuration And Commissioning; Default Values; Sgm Default Values - Emerson Micro Motion SGM Series Configuration And Use Manual

4 Introduction to configuration and
commissioning
Topics covered in this chapter:
•
•
•
•
•
4.1

Default values

Default values for your meter are configured at the factory.
Important
Default values are based on your purchase order options. Therefore, the default values described in
the following tables may not be the factory default values configured for your system. For absolute
accuracy, refer to the configuration sheet that was shipped with your meter.
4.1.1

SGM default values

Table 4-1:
Variable
Line density
Sample temperature
Drive gain
External temperature
External pressure
Base density
Calorific value
Wobbe index
Specific gravity for calibration
range 1
Specific gravity for calibration
range 2
Configuration and Use Manual
Default values
Enable access to the off-line menu of the display
Disable HART security
Set the HART lock
Restore the factory configuration
SGM default mA scaling values
Introduction to configuration and commissioning
Default 4 mA
0 g/cm3
-50.000°C
-58°F
0.000 %
-50.000°C
-58.00000°F
0.000 PSIg
0.000 g/cm3
20 MJ/Nm3
20 MJ/Nm3
0
0
Default 20 mA
0.4 g/cm3
200.000°C
392°F
100.000 %
200.000°C
392.0000°F
1450.377 PSIg
0.400 g/cm3
60 MJ/Nm3
60 MJ/Nm3
0.4
0.4
21