Chapter 6 Configure Measurement Units Using The Display; Configure Measurement Units Using The Display - Emerson Micro Motion SGM Series Configuration And Use Manual

6 Configure measurement units using
the display
Restriction
The display allows you to configure measurement units, but does not support any other process
measurement configuration. To access all process measurement parameters, you must use one of
the following:
•
•
6.1

Configure measurement units using the display

The measurement unit parameters specify the units that will be used for process variables.
1.
2.
3.
4.
5.
Configuration and Use Manual
ProLink III
Field Communicator
Navigate to the Off-Line Maintenance menu and enter it.
Activate Scroll until OFF-LINE CONFIG appears, then activate Select.
When CONFIG UNITS appears, activate Select.
Set the units.
a. When the first process variable appears, activate Select.
b. Activate Scroll to scroll through the options for that process variable.
c. When the desired unit appears, activate Select.
d. Activate Select to store your choice.
e. Repeat until you have set measurement units for all process variables.
When EXIT appears, activate Select to return to the higher-level menu.
Configure measurement units using the display
49