Introduction To Configuration And Commissioning; Default Values; Hfvm Default Values - Emerson MICRO MOTION HFVM Series Configuration And Use Manual

3 Introduction to configuration and
commissioning
Topics covered in this chapter:
•
•
•
•
•
3.1

Default values

Default values for your meter are configured at the factory.
Important
Default values are based on your purchase order options. Therefore, the default values described in
the following tables may not be the factory default values configured for your system. For absolute
accuracy, refer to the configuration sheet that was shipped with your meter.
3.1.1

HFVM default values

Table 3-1:
Variable
Density
Temperature
Drive gain
External temperature
Special equation output
Dynamic viscosity
Kinematic viscosity
Base viscosity
CCAI
CII
Configuration and Use Manual
Default values
Enable access to the off-line menu of the display
Disable HART security
Set the HART lock
Restore the factory configuration
HFVM default mA scaling values for calibration code B (and R)

Introduction to configuration and commissioning

Default 4 mA
0.500 g/cc
0.000°C
32.00°F
0.000 %
-50.000°C
-58.00000°F
0
0 cP
0 cSt
0 cP
800
800
Default 20 mA
1.500 g/cc
150.000°C
302.000°F
100.000 %
150.000°C
302.0000°F
100
100 cP
100 cSt
1000 cSt
1200
1200
15