Change The Label For The Active Calibration; Select The Active Calibration - Emerson Micro Motion SGM Series Configuration And Use Manual

5.6

Change the label for the active calibration

ProLink III
Field Communicator Configure > Manual Setup > Calibration Factors
Overview
You can change the default calibration labels.
Procedure
1.
2.
5.7

Select the active calibration

ProLink III
Field Communicator Configure > Manual Setup > Measurements > Gas Calibration > Active Calibration
Overview
The SGM can store up to four calibrations. The active calibration specifies the calibration to
be used for measurement.
Important
Do not confuse the active calibration with the calibration being performed. For example, you may
perform Calibration 4, and then choose to use Calibration 3 for measurement.
Procedure
Set Active Calibration to the calibration you want to use for measurement.
Related information
Configuration and Use Manual
Device Tools > Calibration Data
Select and delete the value in the Calibration x Label field.
Enter your preferred calibration label and press Apply.
Device Tools > Calibration Data > Active Calibration
Review data for all calibrations
Purging and calibration
47