Configure The Refresh Rate Of Data Shown On The Display; Enable Or Disable Automatic Scrolling Through The Display Variables - Emerson Micro Motion SGM Series Configuration And Use Manual

9.1.4

Configure the refresh rate of data shown on the display

ProLink III
Field Communicator Configure > Manual Setup > Display > Display Behavior > Refresh Rate
Overview
You can set Refresh Rate to control how frequently data is refreshed on the display.
Procedure
Set Refresh Rate to the desired value.
The default value is 1000 milliseconds. The range is 100 milliseconds to
10,000 milliseconds (10 seconds).
9.1.5 Enable or disable automatic scrolling through the
display variables
ProLink III
Field Communicator Configure > Manual Setup > Display > Display Behavior > Auto Scroll
Overview
You can configure the display to automatically scroll through the configured display
variables or to show a single display variable until the operator activates Scroll. When you
set automatic scrolling, you can also configure the length of time each display variable is
displayed.
Procedure
1.
2.
Configuration and Use Manual
Device Tools > Configuration > Transmitter Display > Display Variables
Device Tools > Configuration > Transmitter Display > General
Enable or disable Auto Scroll as desired.
Option Description
Enabled The display automatically scrolls through each display variable as specified by
Scroll Rate. The operator can move to the next display variable at any time using
Scroll.
Disabled Default. The display shows Display Variable 1 and does not scroll automatically.
The operator can move to the next display variable at any time using Scroll.
If you enabled Auto Scroll, set Scroll Rate as desired.
The default value is 10 seconds.
Configure device options and preferences
87