Introduction To Configuration And Commissioning; Default Values And Ranges; Disable Write-Protection On The Transmitter Configuration; Restore The Factory Configuration - Emerson Micro Motion LNG Series Configuration And Use Manual

3 Introduction to configuration and
commissioning
Topics covered in this chapter:
•
•
•
3.1

Default values and ranges

See Default values and ranges
used parameters.
3.2 Disable write-protection on the transmitter
configuration
ProLink III
Overview
If the transmitter is write-protected, the configuration is locked and you must unlock it
before you can change any configuration parameters. By default, the transmitter is not
write-protected.
Tip
Write-protecting the transmitter prevents accidental changes to configuration. It does not prevent
normal operational use. You can always disable write-protection, perform any required configuration
changes, then re-enable write-protection.
3.3

Restore the factory configuration

ProLink III
Overview
Restoring the factory configuration returns the transmitter to a known operational
configuration. This may be useful if you experience problems during configuration.
Configuration and Use Manual
Default values and ranges
Disable write‐protection on the transmitter configuration
Restore the factory configuration
to view the default values and ranges for the most commonly
Device Tools > Configuration > Write-Protection
Device Tools > Configuration Transfer > Restore Factory Configuration

Introduction to configuration and commissioning

15